Anycubic PLA Silk Tri-colour Filament 1kg – Red/Blue/Yellow

Tri-colour silk gradient in one spool | Silky lustrous finish | Compatible with 0.4 mm nozzles and above | Print speeds up to 250 mm/s | Supports intelligent filament identification The Anycubic PLA Silk Tri-colour Filament in Red, Blue, and Yellow is designed for makers who want to elevate decorative prints, fan art, and artistic models beyond single-colour results. Three colours are blended into a single 1 kg spool, producing smooth gradient transitions and a silk-like lustrous finish that shifts visually as the model is rotated. You can fine-tune the surface gloss by adjusting nozzle temperature and print speed — a higher temperature or slower speed increases fluidity and produces a higher-gloss, smoother surface, while cooler or faster settings give a subtler sheen. Compatible with any FDM printer that accepts 1.75 mm filament and a nozzle of 0.4 mm or above, it runs at printing temperatures of 210–240 °C, a heated bed of 55–56 °C, and recommended speeds of 50–250 mm/s. On compatible Anycubic printers the intelligent identification chip is read automatically, streamlining setup without any manual input. A reliable, visually striking choice for decorative and display-quality 3D prints. Features Tri-colour gradient (Red, Blue, Yellow) blended in a single 1 kg spool for layered, multi-tone prints Silk-like lustrous finish that shifts appearance with viewing angle Adjustable gloss — tune nozzle temperature (210–240 °C) and print speed (50–250 mm/s) to control surface sheen Compatible with all 1.75 mm FDM printers using a 0.4 mm or larger nozzle Intelligent identification chip for automatic filament recognition on compatible Anycubic printers Suited to decorative parts, fan art, figurines, and display models Specifications Colour: Red Blue Yellow (#003594,#F3D03E,#D22630) Dry Out Before Use: Recommended Drying Condition: 55-65℃, 6-8h ACE Compatibility: Compatible Nozzle Size: Recommended 0.4 mm or above Printing Temperature: 210-240 ℃ Heated Bed Temperature: 55-56 ℃ Recommended Printing Speed: 50-250 mm/s Maximum Volume Speed (Flow Rate): 8 mm³/s Density: 1.22 g/cm³ Melt Index: 9±1 g/10 min (190℃/2.16kg) Melting Point Temperature: 164 ℃ Vicat Softening Temperature: 54 ℃ Heat Deflection Temperature (0.45MPa): 53 ℃ Young’s Modulus: 2000±200 MPa Tensile Strength: 37±4 MPa Elongation at Break: 28±5% Bending Modulus: 2400±160 MPa Bending Strength: 66±4 MPa lzod lmpact Strength (X-Y): 20±2 kJ/m² Tensile Strength (Z): 12±4 MPa Filament Type: Aesthetic filaments Recommend to Print: Decorative parts, fandom, artworks Intelligent Identification: Supported Reusable Filament Spool: Supported Size: 1KG What’s in the Box Anycubic PLA Silk Tri-colour Filament 1kg – Red/Blue/Yellow x1